REMOVE MAGNET FROM EC-15

™

CONTROLLER, TURN

IGNITION OFF AND DISCONNECT THE WIRING HARNESS

CONNECTOR(S) FROM EC-15

™

CONTROLLER. TURN

IGNITION ON, GROUND LAMP RELAY WIRE (PIN 1K FIG. 7)

(PIN 3F FIG.8) AND NOTE DASH LAMP REACTION.

CHECK DASH WIRING AND

CONNECTORS, AND CONSULT THE

VEHICLE MANUAL FOR TROUBLE

SHOOTING INFORMATION. REPAIR

OR REPLACE AS NECESSARY AND

REPEAT THE “INITIAL START-UP

PROCEDURE”.

RECONNECT THE EC-15

™

CONTROLLER WIRE

HARNESS CONNECTOR(S), AND CHECK FOR

VEHICLE POWER AT THE LAMP RELAY COIL.

TURN IGNITION OFF AND CHECK CONTINUITY OF

WIRING LAMP WIRE BETWEEN EC-15

™

CONTROLLER

WIRING HARNESS CONNECTOR (SEE FIG. 7 & 8) AND

TERMINAL ON LAMP RELAY.

YES

GROUND THIS WIRE AT

EC-15

™

CONTROLLER

CONNECTOR

DASH LAMP OFF?

TO EC-15

™

CONTROLLER

CONNECTOR

LAMP ON

CONTINUE

TESTING

REPLACE EC-15

™

CONTROLLER

IS CONTINUITY DETECTED?

REPAIR OR REPLACE WIRE

HARNESS. RECONNECT EC-15

™

CONTROLLER WIRE HARNESS AND

REPEAT THE “INITIAL START-UP

PROCEDURE”

CHECK

FOR

POWER

HERE

IS POWER DETECTED?

ARE ALL LEDS ILLUMINATED?

TROUBLESHOOTING

SECTION VIII - TESTING FOR FALSE INDICATION CAUSED BY DASH LIGHT RELAY

START HERE

HOLD A MAGNET ON EC-15

™

CONTROLLER

RESET AND NOTE ALL LEDS ILLUMINATED

REPLACE THE RELAY AND REPEAT

THE “INITIAL START-UP PROCEDURE”

REPLACE EC-15

™

CONTROLLER

TESTING THE LAMP RELAY

LAMP

RELAY

TO EC-15

™

CONTROLLER

CONNECTOR

RELAY

LAMP

LAMP ON

BAD RELAY

TESTING THE LAMP RELAY

YES

1 2 ... 18 19 20 21 22 23 24

Komentarze do niniejszej Instrukcji

Brak uwag

ATTO Technology Diamond Storage Array S-Class podręczniki

Instrukcje obsługi i podręczniki użytkownika dla Macierze dyskowe ATTO Technology Diamond Storage Array S-Class.
Dostarczamy 1 pdf podręczników ATTO Technology Diamond Storage Array S-Class do pobrania za darmo według typów dokumentów: Instrukcje Operacyjne