BENDIX M-21-M-22 ANTILOCK MOD ASSY Przewodnik Instalacji Pobierz pdf (Strona 36)

MBS-2 Installation

Stored Faults

To access the flash code identification for a stored fault, turn all power OFF to

the ABS and perform the following steps.

NOTE: This procedure should only be required during annual routine

maintenance or when there is an intermittent problem that does not

show up at stationary power up. For example, if a wheel locks up for an

extended period of time because of a foundation brake malfunction.

1. Power the stop lamp circuit (red) and allow power to remain ON this

circuit until the flash code has been identified (see step 3 below). The

malfunction lamp will light with the stop lamps and then turn OFF.

NOTE: This circuit can be powered with a suitable light tester or by

pulling down on the trailer brake lever in the cab.

2. Power the auxiliary circuit (blue) for one second, power down for one

second, power back up for one second, power down for one second, then

power back up and allow the power to remain ON until the flash code has

been identified (power ON three times).

NOTE: This circuit can be powered with a suitable light tester or by

turning the ignition ON and OFF on newer model tractors.

3. The malfunction lamp will begin flashing a code. The code is identified by

the number of times the lamp illuminates.

NOTE: After the first flash sequence, the lamp will turn OFF briefly then

repeat the flash sequence. This will continue for one minute allowing

time to reach the trailer ABS light and record the number of flashes.

To identify the fault code, refer to the Flash Code Identification Table on page 37.

Before any maintenance is performed, all power must be disconnected from

the system.

If more than one stored fault exists, it will be identified after you clear

each fault.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 54 55

Brak uwag

BENDIX M-21-M-22 ANTILOCK MOD ASSY Przewodnik Instalacji Strona 36